Sierra Wireless AirLink RV50 Series User Manual page 100

ALEOS 4.9.0 Software Configuration User Guide for AirLink RV50 Series
Field
Dynamic Mobile Network Routing
DMNR Enable
Home Address
Home Agent Address
N-MHAE-SPI
N-MHAE-KEY
Subnet 1 – 8
Subnet 1 – 8 NetMask
a. If you disable DMNR when the DMNR tunnel is up, no disconnect message is sent, resulting in a temporary mismatch
between the reachability of the (NEMO) subnets on the gateway and the Home Agent.
Rev 1 Dec. 17
2. Configure the fields as outlined in the following table.
Enables Dynamic Mobile Network Routing. Options are:
Enable
•
a
Disable (default)
•
Note: Configure all the other parameters first and then set this field to Enable. When this
field is set to Enable, the other fields in this window are read-only.
Note: Alway click Apply after enabling or disabling this feature.
Enter a home address for the AirLink gateway. This address is used to distinguish the
AirLink gateway used for DMNR. Use 1.2.3.4 for all gateways configured for DMNR. This
field cannot be left blank.
IP address of the Home Agent (available from your Mobile Network Operator)
NEMO Authentication Extension Security Parameter Index (available from your Mobile
Network Operator)
NEMO Authentication Extension Key (available from your Mobile Network Operator)
Note: The value regularly used successfully for gateways on the Verizon Wireless
network (subject to change) is VzWNeMo.
Enter the IP addresses for the subnets you want to include in the DMNR network. You
can configure up to 8 subnets.
0.0.0.0 indicates that the subnet is not configured.
Note: If you want to remove a subnet from the DMNR configuration, replace the IP
address with 0.0.0.0 rather than deleting it.
Enter the subnet masks for the subnets you want to include in the DMNR network.
0.0.0.0 indicates that the subnet mask is not configured.
Note: If you want to remove a subnet mask from the DMNR configuration, replace the IP
address with 0.0.0.0 rather than deleting it.
100
Description
41111088