Sierra Wireless AirLink RV50 Series User Manual page 473

Command
[prefix]Provision <APN> <Network
User ID> <Network Password>
<Network Authentication Mode>
Note: You can omit any of the above
parameters.
To omit a parameter before the one
•
you want to change, use a period (.)
in place of the omitted parameter.
Example: &&&provision .
user@carrier.com . chap
changes only the user ID and authen-
tication mode.
If you want to omit any parameters
•
after the one you want to change,
simply omit them.
Example: &&&provision access.apn
changes only the apn.
Note: Use of this command is valid for
LTE, HSPA, and GPRS networks, but not
valid for CDMA only networks.
[prefix]AVMS <server> <interval>
Note: All of the above must be on a single
line. The interval must be greater than 0.
Omitting any field results in a response of
"not set" and the configuration parameter
does not change.
[prefix]AVMSCHECKIN
Rev 1 Dec. 17
Action
After the unit is installed and
the SIM card inserted, you
can use this command to
provision the account.
Network Authentication
Mode is optional. If used,
enter one of the following:
None
•
PAP
•
CHAP
•
These are not case
sensitive.
If an unknown mode is
entered or the field is
omitted, None is used.
Modifies the ALMS server's
URL and ALMS
communication period
(interval in minutes)
Prompts the device to
communicate with the ALMS
server. Once AirLink
Management Service
receives the heartbeat
message, it can respond and
send an MSCI command to
the device (i.e Write/Read/
Firmware Update).
473
SMS Commands
Result
"provision"
"apn:" <APN>
"user ID" <Network User ID>
"PW" <Network Password>
"auth mode" <Network Authentication Mode>
Note: If a parameter is omitted, the response
displays "Not Set" for that parameter.
"AVMS"
"srv:" <Server>
"interval:" <Interval>
"AVMS connection requested"
41111088