Sierra Wireless AirLink RV50 Series User Manual page 469

Table D-15: Admin > Advanced Commands
Command
*MSCIUPADDR
*MSCIUPDPERIOD
NSLOOKUP
*POWERIN?
*RESETCFG
*REMOTELOG
Rev 1 Dec. 17
Query or set the IP address or FQDN and port that periodic device status updates
are sent to.
AT*MSCIUPADDR[IP address or FQDN][/port]? to query
AT*MSCIUPADDR=[IP address or FQDN][/port] to set
Examples: 192.168.14.100/3333
MyDevice.com/3333
Query or set the device status update interval (in seconds). This specifies how
frequently the device status update is sent to the port configured in *MSCIUPADDR.
AT*MSCIUPDPERIOD? to query
AT*MSCIUPDPERIOD=n to set
n=0—Disabled
•
n=1–255 seconds
•
Immediately performs an NSLookup on the supplied FQDN.
ATNSLOOKUP=[FQDN]
Query the voltage input to the internal hardware.
AT*RESTCFG resets the device to factory default settings.
Important:
There is no confirmation requested. The AT command takes effect
immediately.
Exports the log file to a remote destination (Syslog Server).
AT*REMOTELOG=<server>[,<port>,<format>,<protocol>,<encrypt>] where:
parameters between brackets are optional. If the port is not specified, the default
port, 514, is used.
Note: This AT command is backwardly compatible with the existing AT command
AT*REMOTELOG=<server>,<port>.
469
Description
AT Commands
41111088