Sierra Wireless AirLink RV50 Series User Manual page 418

ALEOS 4.9.0 Software Configuration User Guide for AirLink RV50 Series
Table D-4: WAN / Cellular AT Commands
Command
*NETAPN
*NETIPPREF
*NETPW
Rev 1 Dec. 17
Query or set the user entered APN.
AT*NETAPN? to query
AT*NETAPN=<apn> to set (up to 80 characters)
Examples:
AT*NETAPN?
<apn>
OK
AT*NETAPN=<apn>
OK
Note: When you set this command, the APN type is automatically set to User Entry
so that the APN you enter with this AT command is used on reboot.
If this command is used with an AirLink RV50 Series gateway, the query or set
applies to the Active SIM. Use
specific SIM card, based on the slot it is installed in.
Query or set the IP Address Preference.
Note: To use IPv6, it must be supported by your Mobile Network Operators and your
account (SIM and APN).
AT*NETIPPREF? to query
AT*NETIPPREF=n to set
n=0—IPv4
•
n=1—IPv4 and IPv6 Gateway
•
To determine the current network IP type, see
Query or set the mobile network account password.
AT*NETPW? to query
AT*NETPW=<password> to set (up to 128 characters)
Note: AT*NETPW? returns asterisks (****) for privacy.
Examples:
ATNETPW?
*******
OK
AT*NETPW=<password>
OK
If this command is used with an AirLink RV50 Series gateway, the query or set
applies to the Active SIM. Use
specific SIM card, based on the slot it is installed in.
418
Description
*SIM1NETAPN or *SIM2NETAPN
*NETCONNTYPE?
*NETPWSIM1 or *NETPWSIM2
to query or set a
on page 405.
to query or set a
41111088