Table D-8: Services AT Commands
Command
*IPMANAGER1
*IPMANAGER2
*IPMGRKEY1
*IPMGRKEY2
*IPMGRUPDATE1
*IPMGRUPDATE2
Rev 1 Dec. 17
Description
Note: This AT command is only usable if the Dynamic DNS Service type is
set to IP Manager.
Query or set a FQDN or IP address of the IP server to send IP change
notifications to. You can configure two independent IP Manager servers.
AT*IPMANAGER[n]? to query
AT*IPMANAGER[n]=SERVER to set.
n=1—First IP Manager server
•
n=2—Second IP Manager server
•
SERVER=Server FQDN or IP address
•
Note: You can disable updates to a server by setting blank entry
(e.g., "AT*IPMANAGER1=").
Note: This AT command is only usable if the Dynamic DNS Service type is
set to IP Manager.
Query or set the 128-bit password/key used to authenticate the IP update
notifications. If the key's value is all zeros, a default key is used. If all the
bytes in the key are set to FF, then no key is used (i.e., the IP change
notifications will not be authenticated).
AT*IPMGRKEY[n]? to query
AT*IPMANAGER[n]=KEY to set
n=1—First IP Manager server
•
n=2—Second IP Manager server
•
KEY=128-bit key in hexadecimal [32 hex characters]
•
Note: This AT command is only usable if the Dynamic DNS Service type is
set to IP Manager.
Query or set the interval (in minutes) to send an IP update notification to the
corresponding server. This occurs even if the IP address of the device does
not change. If the value is set to 0, then periodic updates are not issued (i.e.,
IP change notifications is only be sent when the IP actually changes).
AT*IPMGRUPDATE[n] to query
AT*IPMGRUPDATE[n]=INTERVAL to set
n=0—Disables the update interval (updates only on changes)
•
n=1—First IP Manager server
•
n=2—Second IP Manager server
•
INTERVAL=1–255—interval (in minutes) to send an update
•
439
AT Commands
41111088