Sierra Wireless AirLink RV50 Series User Manual page 413

Table D-4: WAN / Cellular AT Commands
Command
*DOWNBURST
*DOWNBYTES?
*DOWNDROPPED?
*DOWNPACKETS?
*ENASIMPIN
*ETHWAN_IPMODE
Rev 1 Dec. 17
Query or set the maximum size for bursts of downlink traffic.
AT*DOWNBURST? to query
AT*DOWNBURST=n to set
n=64–512000—Maximum size for bursts of downlink traffic in Kilobits (Kb). This
•
allows the gateway to handle temporary bursts of traffic without dropping
packets. When the actual downlink traffic is less than the value configured in
*DOWNBAND, ALEOS collects credits that can be used for bursty traffic. The
value configured here is the maximum amount of credit that can be collected.
Default value is 51200.
Note: Sierra Wireless recommends that the Maximum Downlink Burst Size be set at
2× the value configured in the
Size is set at more than 60× the value configured in the
bandwidth throttle feature is disabled for downlink traffic.
Query the number of downlink bytes received.
AT*DOWNBYTES?
The value is updated every 30 seconds, and is reset to zero on gateway reboot or
reset to factory default settings.
Query the number of downlink packets dropped because the limit set in
*DOWNBAND and *DOWNBURST
AT*DOWNDROPPED?
The value is updated every 30 seconds, and is reset to zero on gateway reboot or
reset to factory default settings.
Query the number of downlink packets received.
AT*DOWNPACKETS?
The value is updated every 30 seconds, and is reset to zero on gateway reboot or
reset to factory default settings.
Query, enables or disables the SIM PIN lock on the Active SIM card, When enabled,
the SIM card requests this PIN when the gateway boots up. (If the ALEOS SIM PIN
feature is also enabled, the PIN will be entered automatically. This is useful if the
gateway is at a location where no one is available to enter the PIN. For more
information see Enable the SIM PIN
AT*ENASIMPIN? to query
0—SIM PIN is not required at boot.
•
1—SIM PIN ls required at boot.
•
AT*ENASIMPIN=<lock>,<PIN> to set, where:
<lock> = 0—SIM PIN is not required at boot.
•
<lock> = 1—SIM PIN ls required at boot.
•
<PIN> = The current PIN
•
Query or set the Ethernet WAN IP mode
AT*ETHWAN_IPMODE? to query
AT*ETHWAN_IPMODE=n to set
0—Dynamic
•
1—Static
•
413
Description
*DOWNBAND field. If the Maximum Downlink Burst
*DOWNBAND
have been exceeded.
on page 83 and *SIMPINENABLE
AT Commands
field, the
on page 424.)
41111088