Sierra Wireless AirLink RV50 Series User Manual page 463

Table D-11: Standard (Hayes) AT Commands
Command
S211
S221
V
&V
&W
X
Z
Rev 1 Dec. 17
Description
For applications or situations where hardware control of the DTR signal is not possible, the
device can be configured to ignore DTR. When Ignore DTR is enabled, the device operates
as if the DTR signal is always asserted.
ATS211? to query
ATS211=n to set
n=0—Use hardware DTR (default)
•
n=1—Ignore DTR
•
n=3—Ignore DTR and assert DSR.
•
Query or set the Connect Delay—the number of seconds to delay the connect response
when establishing a TCP connection.
ATS211? to query
ATS211=n to set
n=0–255
•
Query or set the AT command responses (verbosity).
ATV? to query
ATVn to set
n=0—Numeric (terse) command responses (The numeric responses follow the Hayes
•
Standards for commands.)
n=1—Text string (verbose) command responses (default)
•
Note: Do not use an equal sign (=) when issuing the command.
Lists most AT commands and their current values. If the parameter is not configured, the AT
command returns "Not Set".
Saves the settings for parameters that are temporarily set without being permanently written
to the memory.
This command does not apply to ALEOS because once you issue an AT command or
change a setting in ACEmanager and click Apply, the changes are saved in non-volatile
memory and are persist across reboots.
Query or set the Extended Call Process Result mode.
ATX? to query
ATXn to set
n=0—No extended code (default)
•
n=1—Adds the text 19200 to the connect response
•
Reboots the AirLink gateway.
Note: If *DATZ is set to 1, Z is blocked. See
463
*DATZ on page 460.
AT Commands
41111088