ALEOS 4.9.0 Software Configuration User Guide for AirLink RV50 Series
Rev 1 Dec. 17
A single Action may be activated by one or more Events. For example, if either the
network state changes to Network Ready or the RSSI crosses a configured
threshold, the same Action is performed.
Configuring Events Reporting
Before you begin
If you plan to use either of the following, configure that feature in ACEmanager
before configuring Events Reporting:
•
Email
(Email (SMTP)
•
SNMP Trap
(Management (SNMP)
Configuring Events Reporting
When configuring Events Reporting, first configure the Action (that is, how you
want to be notified when the Event occurs). Then configure the Event you want
reported, and finally, link the Event to the Action.
Note: All Events Reporting configuration changes take effect after a short delay (about one
minute). No reboot of the AirLink gateway is necessary.
Configuring the Action
Note: You can define a maximum of 5 Actions.
If an Action requires an IP connection, the following source ports are used. These
are not configurable.
Actions (in the order configured)
Action 1
Action 2
Action 3
Action 4
Action 5
Click the appropriate link for instructions on configuring the desired Action. Once
the Action is configured, proceed to
•
Email
•
SMS
•
Relay Link
•
SNMP TRAP
•
Location Reports
·
Location RAP Report 13
248
on page 209)
on page 212)
Source port
17348
17349
17351
17352
17353
Event Types
on page 260.
41111088