Applying A Template - Sierra Wireless AirLink RV50 Series User Manual

ALEOS 4.9.0 Software Configuration User Guide for AirLink RV50 Series
Note: Sierra Wireless
recommends resetting the
gateway to the factory
default settings before
applying the template.
Rev 1 Dec. 17
Do not attempt to change settings directly in the template file. Changing
Warning:
settings in the template file could result in unexpected behavior in the AirLink gateway.
Alter the template only if you are specifically directed to do so by your distributor or Sierra
Wireless Technical Support.
Tip: If you want to compare a new template with the previous one, download and save the
old template before applying the new one. You can use any 3rd party text comparison tool
to check the differences between two templates.

Applying a Template

Note: If you are using Internet Explorer 9 to upload the template, see
page 474 for instructions on configuring the browser's Internet options to allow the upload.
To upload and apply a template to an AirLink gateway:
1. Connect the computer (where the template is saved) to the AirLink gateway
you want to upload the template to, or connect to the gateway over the air.
2. Log in to ACEmanager, and go to Admin > Advanced.
3. Select the Reset Mode:
· Preserve Cellular Authentication Settings—Recommended if you are
applying a template remotely using a remote ACEmanager connection (or
ALMS). For a list of preserved settings, see
· Reset All— Recommended if you are applying a template locally (i.e your
computer is physically connected to the gateway).
4. Once the gateway reboots, log in to ACEmanager.
5. In ACEmanager, click the Template button on the toolbar.
Figure 2-8: ACEmanager: Template button
20
Templates on
Reset Mode on page 319.
41111088