Sierra Wireless AirLink RV50 Series User Manual page 408

ALEOS 4.9.0 Software Configuration User Guide for AirLink RV50 Series
Table D-4: WAN / Cellular AT Commands
Command
*ACTIVESIM?
*AUTOPRL
*AUTOPRLFREQ
Rev 1 Dec. 17
Table D-3: Summary of SIM Card AT Commands
Command
*SIM1PINENABLE Queries, enables, or disables the ALEOS SIM PIN feature for the
SIM card in slot 1. When enabled, ALEOS automatically enters the
SIM PIN requested by the SIM card when the gateway starts up.
*SIM2PINENABLE Queries, enables, or disables the ALEOS SIM PIN feature for the
SIM card in slot 2. When enabled, ALEOS automatically enters the
SIM PIN requested by the SIM card when the gateway starts up.
*SIMPIN Sets the SIM PIN that ALEOS automatically enters for the Active
SIM if the ALEOS SIM PIN feature is enabled. This should match
the SIM PIN set on the SIM card, either by the mobile network
operator or by using *CHGSIMPIN.
*SIM1PIN Sets the SIM PIN that ALEOS automatically enters for the SIM
card in slot 1 if the ALEOS SIM PIN feature is enabled. This
should match the SIM PIN set on the SIM card, either by the
mobile network operator or by using *CHGSIMPIN.
*SIM2PIN Sets the SIM PIN that ALEOS automatically enters for the SIM
card in slot 1 if the ALEOS SIM PIN feature is enabled. This
should match the SIM PIN set on the SIM card, either by the
mobile network operator or by using *CHGSIMPIN.
*ENASIMPIN Queries, enables, or disables the PIN lock on the Active SIM card.
*CHGSIMPIN Changes the PIN on the Active SIM card if the PIN lock is enabled
Query the Active SIM card, i.e., which SIM card is currently being used for the data
connection.
AT*ACTIVESIM? to query
1—The SIM card in slot 1 (upper slot) is the Active SIM.
•
2—The SIM card in slot 2 (lower slot) is the Active SIM.
•
CDMA only.
Query or set automatic Preferred Roaming List updates.
AT*PRL? to query
AT*PRL=n to set
n=0—Disable
•
n=1—Enable
•
Note: To query the current PRL, use +PRL?.
CDMA only.
Query or set how often the PRL automatically updates.
AT*AUTOPRLFREQ? to query
AT*AUTOPRLFREQ=n to set
n= interval to check for updates (in days)
•
408
What it does
Description
41111088