Sierra Wireless AirLink RV50 Series User Manual page 424

ALEOS 4.9.0 Software Configuration User Guide for AirLink RV50 Series
Table D-4: WAN / Cellular AT Commands
Command
*SIM1PIN
*SIM2PIN
*SIMPINENABLE
Rev 1 Dec. 17
Sets the SIM PIN that ALEOS automatically entered for the SIM in slot 1 if the ALEOS
SIM PIN feature is enabled. This should match the SIM PIN set on the Active SIM
card, either by the mobile network operator or by using *CHGSIMPIN. See
*CHGSIMPIN on page 410.
*SIM1PIN=<pin> to enter the SIM PIN
Example:
AT*SIM1PIN=<pin>
OK
Sets the SIM PIN that ALEOS automatically entered for the SIM in slot 2 if the ALEOS
SIM PIN feature is enabled. This should match the SIM PIN set on the Active SIM
card, either by the mobile network operator or by using *CHGSIMPIN. See
*CHGSIMPIN on page 410.
*SIM2PIN=<pin> to enter the SIM PIN
Example:
AT*SIM2PIN=<pin>
OK
Query, enable, or disable the ALEOS SIM PIN feature. When enabled, ALEOS
automatically enters the SIM PIN requested by the SIM card on boot up. This is useful
if the gateway is at a location where no one is available to enter the PIN.
AT*SIMPINENABLE? to query
AT*SIMPINENABLE=<setting> to set
<setting>=0—Don't change
•
<setting>=1—Enable (SIM pin required on startup)
•
<setting>=2—Disable
•
AT*SIMPINENABLE?
<setting>
OK
AT*SIMPINENABLE=<setting>
OK
If this command is used with an AirLink RV50 Series gateway, the query or set
applies to the Active SIM. Use
set a specific SIM card, based on the slot it is installed in.
To enable or disable the SIM PIN lock on the SIM card, see
424
Description
*SIM1PINENABLE or *SIM2PINENABLE to query or
*ENASIMPIN on page 413.
41111088