ALEOS 4.9.0 Software Configuration User Guide for AirLink RV50 Series
Table D-10: Serial AT Commands
Command
*UALL
*UDPLAST
*UDPPADMTU
*USD
Rev 1 Dec. 17
Description
Query or set the ability to accept UDP packets from any IP address when a UDP
session is active. If there is no UDP session active, an incoming UDP packet will be
treated according to the UDP auto answer and AIP settings.
AT*UALL? to query
AT*UALL=n to set
n=0—No effect (default)
•
n=1—Accept UDP data from all IP addresses when in a UDP session
•
Query or set the option to set S53 to the last accepted IP address through UDP auto
answer. This can be used in conjunction with MD3 so that when there is no UDP
session, new Ethernet host data will cause a connection to be restored to the last IP
accepted through UDP auto answer.
AT*UDPLAST? to query
AT*UDPLAST=n to set
n=0—Does not change destination IP (default)
•
n=1—Change destination IP to last received
•
Query or set the size of serial MTU (PAD payload).
AT*UDPPADMTU? to query
AT*UDPPADMTU=n to set
n=256–4096
•
Query or set the specified delay before sending the UDP packets out the serial port.
AT*USD? to query
AT*USD=n to set
n=0—No UDP packet delay (default)
•
n=1–255—Delay in 100 ms units, from 100 ms to 25.5 sec.
•
458
41111088