Sierra Wireless AirLink RV50 Series User Manual page 117

Field
General
USB Device Mode
Device USB IP
Host USB IP
Rev 1 Dec. 17
you can disable it to prevent access by USB. You may need to install a USB driver
to use these modes. For more information, see
page 118.
By default, the port is set to work as a virtual Ethernet port.
Note: Sierra Wireless recommends that you use a USB 2.0 cable with your AirLink
gateway and connect directly to your computer for best throughput.
To change the USB port to allow virtual serial port communication:
1. In ACEmanager, go to LAN > USB, and choose USB Serial as the USB
Device Mode.
To disable the USB port, select Disable from the same menu.
Figure 5-3: ACEmanager: LAN > USB
Description
The USB mode on gateway startup
USB Serial—USB port acts as a virtual Serial port.
•
USBNET—USB port acts as a virtual Ethernet port. (default)
•
Disabled—USB port is disabled.
•
You can also configure this parameter using the AT Command *USBDEVICE. See
*USBDEVICE on page 429.
Note: A reboot is required to activate the USB mode change.If you want to stream
Location data to the USB port
The USBNET IP address of the AirLink gateway. By default this is set to 192.168.14.31.
The IP for the computer or device connected to the USB port
117
Installing the USB Drivers
(Local/Streaming on page 241), set this field to USB Serial.
LAN Configuration
on
41111088