Sierra Wireless AirLink RV50 Series User Manual page 405

Table D-2: Status AT Commands
Command
?LISTIP
*LTERSRQ?
*LTERSRP?
*NETCHAN?
*NETCONNTYPE?
NETIP?
*NETIPV6?
*NETIPV6PREFIXLEN?
Rev 1 Dec. 17
Description
Query the IP/MAC address information for connected LAN devices.
This AT command retrieves the information available on the IP/MAC table on the
Status > LAN screen.
AT?LISTIP
The response lists the IP address, the MAC address, and the status. Fields are
separated by semi-colons.
Example:
192.168.14.100;0e:c6:ff:b2:61:8f;active
LTE only.
Query the LTE signal quality (in dB).
For more information, see
LTE only.
Query the LTE signal strength (in dBm).
For more information, see
Query the current mobile network channel.
Query the current IP address type.
AT*NETCONNTYPE?
0—None
•
1—IPv4
•
3—IPv4 and IPv6 Gateway
•
Note: To set the IP address type preference, see
Query the current WAN IP address of the device reported by the internal module
(generally obtained from your Mobile Network Operator). If you have an Internet-
routable IP address, you can use this address to contact devices from the Internet. If
your device on a private mobile network, you can use this address to contact the
device from another host on the same WAN network.
If required, use AT*NETALLOWZEROIP
zero.
Note: If there is no current network IP address, 0.0.0.0 is returned.
Query the current IPv6 network IP address of the device reported by the internal
module (generally obtained from your Mobile Network Operator).
If you have an Internet-routable IP address, you can use this address to contact
devices from the Internet. If your device is on a private mobile network, you can use
this address to contact the device from another host on the same WAN network.
Note: If there is no current network IPv6 address, "::" (two colons) is returned.
Query the length of the network IPv6 prefix.
AT*NETIPV6PREFIXLEN?
If there is no IPv6 connection, 0 is returned.
405
LTE Signal Quality (RSRQ)
LTE Signal Quality (RSRQ)
*NETIPPREF
to allow displaying an IP address ending in a
AT Commands
on page 42.
on page 42.
on page 418.
41111088