Sierra Wireless AirLink RV50 Series User Manual page 240

ALEOS 4.9.0 Software Configuration User Guide for AirLink RV50 Series
Event / Action
The AirLink gateway in the police car is
connected to power for the first time.
The police car is driving around the patrol area. A 0x12 (Location + Date) report is sent every 150 meters or every 30
The police officer spots a speeding vehicle,
switches on the siren, and pursues the vehicle.
The vehicle speeds up, with the police car in
pursuit.
The vehicle being pursued and the police car
slow down.
The speeding vehicle pulls over and stops at
the side of the road. The police car pulls in
behind it. The officer turns off the siren, leaves
the engine idling, gets out of the car, and
walks over to the other vehicle.
The officer issues a ticket, returns to the police
car and drives away.
Rev 1 Dec. 17
Figure 9-5: ACEmanager: Location > Server 1—Example
The following table provides a sample scenario for this ALEOS configuration.
A 0x10 (power up) report is sent.
seconds, whichever is less.
Digital input 2 which is connected to the siren switch is triggered and a
0x27 (DIN 2 changes to 1) report is sent.
When the police car exceeds 100 km/h, a 0x2e (maximum speed
exceeded) report is sent. A 0x12 (Location + Date) report is sent every
150 meters.
When the police car's speed goes below 100 km/h, a 0x2f (return to
normal speed) report is sent.
Digital input 2 which is connected to the siren switch is triggered, and a
0x26 (DIN 2 changes to 0) report is sent. Six seconds after the police car
comes to a stop, a 0x2c (stationary vehicle event) report is sent. While
the car remains stopped with the engine idling, a 0x12 (Location + Date)
report is sent every 5 minutes.
When the police car is back in motion, a 0x2d (started moving event)
report is sent. A 0x12 (Location + Date) report is sent every 150 meters
or 30 seconds, whichever is less.
240
Location RAP report sent to the server
41111088