Udp Multiple Unicast - Sierra Wireless AirLink RV50 Series User Manual

ALEOS 4.9.0 Software Configuration User Guide for AirLink RV50 Series
Rev 1 Dec. 17
ALEOS redirects you to the router or other device connected to the AirLink
gateway serial port. You can use this connection to configure connected device.
Note: You may be required to enter a user name and password to access the router or
other device.

UDP Multiple Unicast

With UDP Multiple Unicast, data from the serial port is packed into UDP packets
and sent to multiple IP addresses. To configure UDP Multiple Unicast:
1. Log in to ACEmanager as "user" and go to Serial > Port Configuration > Port
Configuration.
2. In the Startup Mode Default field, select UDP Multiple Unicast.
3. In the Destination Port field, enter the remote port to be used.
4. Click Apply.
5. Go to Serial > Modbus Address List and enter the index numbers and IP
addresses of the devices you want the data sent to. (See
List on page 281.)
6. Click Apply.
7. Reboot the device.
Note: To avoid flooding the network, there is a 20 millisecond pause between sending the
UDP packet to each destination.
270
Modbus Address
41111088