Sierra Wireless AirLink RV50 Series User Manual page 448

ALEOS 4.9.0 Software Configuration User Guide for AirLink RV50 Series
Table D-9: Location AT Commands
Command
*PPDIST
*PP2DIST
*PP3DIST
*PP4DIST
*PPDISTM
*PP2DISTM
*PP3DISTM
*PP4DISTM
*PPDEVID
*PPFLUSHONEVT
Rev 1 Dec. 17
Description
Query or set the Location report distance interval in 100 meter units. For example, if
you entered a value of 635, it would translate to 63,500 meters (63.5 kilometers).
AT*PP[Server number if other than server 1]DIST? to query
AT*PP[Server number if other than server 1]DIST=n to set
n=0—Disabled
•
n=1–65535—Distance in 100 meter units that the device moves before sending a
•
Location report
Query or set the Location report distance Interval in meters.
AT*PP[Server number if other than server 1]DISTM? to query
AT*PP[Server number if other than server 1]DISTM=n to set
n=0—Disabled
•
n=40–65535—Distance in meters that the device moves before sending a
•
Location report
Note: If you enter a value greater than zero, but less than 40, ALEOS rounds it up to 40.
Query or set whether or not the RAP Location report includes device ID and if so, which
type of device ID is included.
AT*PPDEVID? to query
AT*PPDEVID=n to set
n=0—None
•
n=1—Phone number
•
n=2—ESN/IMEI
•
Note: The device ID in the RAP report is in hex, not plain text.
Query or set Send SnF Buffer Immediately on input. If this feature is enabled, any
pending stored reports are sent if the I/O input changes, a stationary vehicle is moved,
or a maximum speed is exceeded.
AT*PPFLUSHONEVT? to query
AT*PPFLUSHONEVT=n to set
n=0—Disable
•
n=1—Enable
•
448 41111088