Sierra Wireless AirLink RV50 Series User Manual page 456

ALEOS 4.9.0 Software Configuration User Guide for AirLink RV50 Series
Table D-10: Serial AT Commands
Command
IPL
*NUMTOIP
S50
S51
S53
Rev 1 Dec. 17
Description
Query or set the IP list dial.
AT*IPL? to query
AT*IPL=n to set
n=0—Disable
•
n=1—Enable
•
This allows you to access to the Modbus IP address list using the first two digits of
the dial string.
Example: ATDT1234567 would go to ID "12" on the Modbus list and use the
associated IP as the destination.
Query or set the option to convert a 12-digit number to an IP address.
For example, converts 111222333444 to 111.222.333.444
AT*NUMTOIP? to query
AT*NUMTOIP=n to set
n=0—Disable
•
n=1—Enable
•
Query or set the data forwarding idle timeout.
ATS50? to query
ATS50=n to set
n=0—a forwarding timeout of 10 ms is used.
•
n=tenths of a second
•
Query or set the PAD data forwarding character. ASCII code of character that
causes data to be forwarded. Used in UDP or TCP PAD mode.
ATS51? to query
AT51=CHARACTER to set
n=0—No forwarding character
•
n=CHARACTER
•
Query or set the method (dial mode), destination IP address, and port used as
defaults for the D (Dial) AT command.
ATS53? to query
ATS53=[method][d.d.d.d][/ppppp] to set
[method] can be:
P—UDP
•
T—TCP
•
[d.d.d.d] is the destination IP address
[pppp] is the port number.
Example:
ATS53=P111.22.33.44/5555
where:
The first character is the dial mode (P in this example)
•
Followed by destination IP address (111.22.33.44 in this example)
•
A slash
•
Followed by the destination port (5555 in this example)
•
You can also use this command to set only the port. For example, AT53=/7777.
456 41111088