Sierra Wireless AirLink RV50 Series User Manual page 402

ALEOS 4.9.0 Software Configuration User Guide for AirLink RV50 Series
Table D-2: Status AT Commands
Command
+CIMI?
*DEVICEID?
*DNS1?
*DNS2?
+ECIO?
*ETHMAC?
*ETHSTATE?
*SERIALNUM?
*HOSTCOMMLVL?
+HWTEMP?
I[n]
+ICCID?
Rev 1 Dec. 17
Description
HSPA and LTE only.
Query the IMSI.
When the device is configured to use the device ID with Location reports, this
command displays the 64-bit device ID created from the ESN/IMEI or phone, preceded
by the hex delimiter (0x). For example:
at*deviceid?
0x010112DE140B5A32
Note: If the device is not configured to use the device ID with Location reports, the
command returns "NOT SET".
Query the primary DNS (*DNS1) and secondary (*DNS2) IP addresses.
AT*DNS1? to query DNS1
AT*DNS2? to query DNS2
Query the signal quality.
Query the MAC address of the Ethernet port.
AT*ETHMAC? or AT*ETHMAC?1—Returns the MAC address of the main
•
Ethernet port
Query the connection state (speed and duplex) of the Ethernet port.
AT*ETHSTATE? or AT*ETHSTATE?1—Returns the speed and duplex state of the
•
main Ethernet port (e.g. 100Mb/s Full Duplex)
Query the serial number used by ALMS to identify the device.
Query the serial host signal level.
Response example: DCD:LOW; DTR:LOW; DSR:HIGH; CTS:HIGH; RTS:LOW
Query the internal temperature of the radio module (in degrees Celsius).
Query device information.
n omitted—device model
•
n=0—device model
•
n=1—ALEOS software version, hardware revision, boot version
•
n=2—Radio module firmware version
•
n=3—Radio module's unique ID (ESN, IMIEI, or EID)
•
HSPA and LTE only.
Query the SIM ID.
402 41111088