Applications - Sierra Wireless AirLink RV50 Series User Manual

ALEOS 4.9.0 Software Configuration User Guide for AirLink RV50 Series
Field
TCP Auto Answer
UDP Auto Answer
Serial bytes sent
Serial bytes received
Host signal level
Rev 1 Dec. 17
Description
This parameter determines how the AirLink gateway responds to an incoming TCP
connection request. The AirLink gateway remains in AT Command mode until a connection
request is received. DTR must be asserted (S211=1 or &D0) and the gateway must be set
for a successful TCP connection. The AirLink gateway sends a "RING" string to the host. A
"CONNECT" sent to the host indicates acknowledgment of the connection request and the
TCP session is established.
Disabled (default)
•
Enabled
•
How UDP auto answer mode is configured
Disabled (default)
•
Enabled
•
Number of bytes sent over serial port to host
Number of bytes received over serial port from host
Status of the following parameters related to the host signal level:
DCD—Data Carrier Detect—Control signal to the PC
•
DTR—Data Terminal Ready—Used to establish a connection
•
DSR—Data Set Ready—Used to establish a connection
•
CTS—Clear to Send—Data flow control
•
RTS—Request to Send—Data flow control
•
Each parameter can have a value of LOW (signal not asserted) or HIGH (signal being
asserted).
The first three parameters (DCD, DTR, and DSR) may be helpful for troubleshooting. If the
values shown for these parameters are not as expected:
1. Press Refresh to ensure you have the latest values.
2. Check the cable connections.
Note: ACEmanager does not update dynamically. Press Refresh to view the current
values.

Applications

The Applications section of the Status group provides information on the status of
the Garmin gateway and data service.
Figure 3-10:
56 41111088