Reliable Static Routing (Rsr); Inbound Ports Used By Aleos - Sierra Wireless AirLink RV50 Series User Manual

ALEOS 4.9.0 Software Configuration User Guide for AirLink RV50 Series
Rev 1 Dec. 17
The solution: Low Voltage Standby mode settings take effect as soon as you
click Apply, but they are not permanently stored until the gateway is rebooted. To
bring a gateway out of Low Voltage Standby mode if the Resume immediately at
Voltage field is set too high:
1. Connect the gateway to a power source and supply voltage that is greater
than the value configured in the Resume immediately at Voltage field.
2. When the gateway resumes normal operation, launch ACEmanager and reset
the values in the Services > Power Management > Low Voltage Standby fields.
3. While still using the voltage applied in step 1, Click the Reboot button in
ACEmanager to reboot the gateway.
The gateway reboots.
4. Wait until the gateway reboots itself a second time, or for at least 3 minutes, if
you are not sure if the gateway has done its automatic reboot.
Once the second reboot is complete, it is safe to disconnect the gateway from
the higher power source and return it to the original installation and power
source.

Reliable Static Routing (RSR)

I launched ACEmanager with Internet Explorer 9. I configured RSR,
but after I enabled RSR and clicked Apply, all the values reverted to
the defaults.
There is a known issue. If you configure and enable RSR with ACEmanager in
Internet Explorer 9, and then click Apply, the values in the ACEmanager screen
appear as default values.
This is an ACEmanager display issue only. The configuration is applied properly,
but the configured values are not displayed. Click Refresh to view the configured
values.

Inbound Ports Used by ALEOS

When I configure ports for an application on a LAN client such as a
router or laptop, I want to ensure that the ports I use do not conflict
with the inbound ports that ALEOS uses. Which ports does ALEOS
use?
Table F-1 shows the inbound ports that are set in ALEOS and cannot be
configured. Table F-2 show the default setting for ports you can configure and
where to change the ports in ACEmanager.
480 41111088