Sierra Wireless AirLink RV50 Series User Manual page 426

ALEOS 4.9.0 Software Configuration User Guide for AirLink RV50 Series
Table D-4: WAN / Cellular AT Commands
Command
*SIM2PRESENT?
*SWITCHSIM
*TRAFWUPTOUT
*UPBAND
Rev 1 Dec. 17
Query whether or not there is a SIM card installed in SIM slot 2.
AT*SIM1PRESENT? to query
0—No SIM card in slot 2
•
1—SIM card present in slot 2
•
Examples:
AT*SIM2PRESENT?
<Slot 2 SIM status>
OK
Change which SIM card slot contains the active SIM card. If there is no SIM card in
the inactive SIM card slot, an error message ("SIM Switching impossible, no SIM in
inactive slot") is returned.
A reboot is not required.
AT*SWITCHSIM switches the active SIM to the other SIM card slot
To determine whether or not there is a SIM card in the inactive SIM card slot, use
*SIM2PRESENT? and *SIM1PRESENT?.
This AT Command applies only to International devices on the Vodafone network.
Query or set the timeout period after which, if there is no outgoing WAN traffic, the
connection is terminated.
The timeout period only takes effect if
STARTUP is set to 1, or Always on connection is disabled in ACEmanager. (See
Always on connection on page 79.)
AT*TRAFWUPTOUT? to query
AT*TRAFWUPTOUT=n to set
n=2–65535 minutes (default is 2)
•
Note: This timer is reset to zero each time a WAN packet goes out.
Query or set the maximum uplink bandwidth.
AT*UPBAND? to query
AT*UPBAND=n to set
n = 0—Bandwidth Throttle is disabled for uplink traffic
•
n=1–204800—Maximum uplink bandwidth in Kilobits per second (Kbps). This is
•
the long-term bandwidth limit. Default value is 12288.
426
Description
*RADIO_CONNECT or *RADIO_CONNECT_
41111088