Sierra Wireless AirLink RV50 Series User Manual page 451

Table D-9: Location AT Commands
Command
*PPODOM
*PP2ODOM
*PP3ODOM
*PP4ODOM
*PPODOMVAL
*PPPORT
*PP2PORT
*PP3PORT
*PP4PORT
*PPREPORTINPUTS
*PP2REPORTINPUTS
*PP3REPORTINPUTS
*PP4REPORTINPUTS
*PPSIMPLETO
*PP2SIMPLETO
*PP3SIMPLETO
*PP4SIMPLETO
*PPSNF
*PP2SNF
*PP3SNF
*PP4SNF
*PPSNFR
*PP2SNFR
*PP3SNFR
*PP4SNFR
Rev 1 Dec. 17
Description
Query or set including the current odometer reading in the RAP report.
AT*PP[Server number if other than server 1]ODOM? to query
AT*PP[Server number if other than server 1]ODOM=n to set
n=0—Disabled (default) Do not include odometer reading in report.
•
n=1—Enabled Include odometer reading in report.
•
Query or set the odometer value (in meters). Maximum value is approximately 4.3
billion meters (2.7 million miles).
AT*PPODOMVAL? to query
AT*PPODOMVAL=n to set
n=0–4294967295 meters
•
Query or set the port Location reports are sent to.
AT*PP[Server number if other than server 1]PORT? to query
AT*PP[Server number if other than server 1]PORT=n to set
n=0—Disable
•
n=1–65535
•
Query or set input reporting and including the current digital input value in RAP reports.
AT*PP[Server number if other than server 1]REPORTINPUTS? to query
AT*PP[Server number if other than server 1]REPORTINPUTS=n to set
n=0—Disabled
•
n=1—Enabled
•
Query or set the first retry interval for Simple Reliable, UDP Sequence mode, and TCP
transports (in seconds).
AT*PP[Server number if other than server 1]SIMPLETO? to query
AT*PP[Server number if other than server 1]SIMPLETO=n to set
n=0—Disable
•
n=1–255 (default is 10)
•
Query or set the Store and Forward (SNF) setting. SNF causes Location reports to be
stored if the device/vehicle goes outside the area of network coverage. Once the
vehicle is in the coverage area, the Location reports are sent en masse to the server.
AT*PP[Server number if other than server 1]SNF? to query
AT*PP[Server number if other than server 1]SNF=n to set
n=0—Disabled
•
n=1—Enabled (default)
•
Query or set Transport /SNF mode. Location reports are retransmitted if not
acknowledged by the server.
AT*PP[Server number if other than server 1]SNFR? to query
AT*PP[Server number if other than server 1]SNFR=n to set
n=0—Disabled
•
n=1—Reliable mode
•
n=2—Simple Reliable mode
•
n=3—UDP Sequence
•
n=4—TCP Listen
•
n=5—TCP
•
451
AT Commands
41111088