Table 11-3: Serial Port Configuration > TCP
Field
TCP
TCP Auto Answer
TCP Connect Timeout
(seconds)
TCP Idle Timeout
Rev 1 Dec. 17
TCP
Figure 11-3: ACEmanager: Serial > Port Configuration > TCP
Description
This determines how the AirLink gateway responds to an incoming TCP connection
request. The AirLink gateway remains in AT Command mode until a connection request is
received. The AirLink gateway sends a "RING" string to the host. A "CONNECT" sent to the
host indicates acknowledgment of the connection request and the TCP session is
established.
Disable (default)
•
Enable
•
You can also use an AT command to configure this field. See
Specifies the number of seconds to wait for a TCP connection to be established when
dialing out (Default is 30.)
You can also use an AT command to configure this field.
TCP idle time-out in the configured units (See
Specifies a time interval upon which if there is no in or outbound traffic through a TCP
connection, the connection is terminated.
Default is 5.
You can also use an AT command to configure this field. See
273
Serial Configuration
S0
on page 462.
TCP Idle Timeout Unit
on page 274.)
TCPT
on page 457.
41111088