Table D-9: Location AT Commands
Command
*PGPSC
*PGPSD
*PGPSF
*PGPSR
Rev 1 Dec. 17
Description
Query or set the out-of-coverage setting. This setting enables you to configure the
AirLink gateway to stream Location reports to the serial port only when the device has
no cellular coverage. (This enables you to use a back-up in-vehicle mapping application
that does not rely on mobile network coverage.)
AT*PGPSC? to query
AT*PGPSC=n to set
n=0: ALWAYS (default) Location reports are always streamed to the serial port
•
n=1: Out of Coverage—reports are only streamed to the serial port when the
•
AirLink gateway has no mobile network connection.
Note: The two persistent Location report parameters,
the report type and message frequency of reports sent out the serial port when the
AirLink gateway is out of mobile network coverage.
Query or set the delay (in seconds) before the out-of-coverage stream begins sending
the messages out the serial port and not into SnF.
AT*PGPSD? to query
AT*PGPSD=n to set
n=0 (default)
•
n=1–255
•
Note: Any messages put into SnF during this switch-over delay period are sent over
the air when coverage is re-acquired.
Note: The two persistent Location report parameters,
the report type and message frequency of reports sent out the serial port when the
AirLink gateway is out of mobile network coverage.
Query or set how frequently (in seconds) the Location report is sent to the serial link.
AT*PGPSF? to query
AT*PGPSF=n to set
n=0–65535
•
Query or set the Location report type.
AT*PGPSR? to query
AT*PGPSR=n to set
NMEA reports:
n=E0—NMEA GGA + VTG
•
n=E1—NMEA GGA+VTG+RMC
•
n=E2—NMEA GGA+VTG+RMC+GSA+GSV
•
TAIP reports:
n=F0—TAIP data
•
n=F1—TAIP compact data
•
n=F2—TAIP LN report
•
n=F3—TAIP TM report
•
447
AT Commands
*PGPSR
and *PGPSF, control
*PGPSR
and *PGPSF, control
41111088