Example For Configuring Bgp4+ 6Pe - Huawei Quidway NetEngine80E Configuration Manual

HUAWEI NetEngine80E/40E Router
Configuration Guide - IP Routing
l

9.18.4 Example for Configuring BGP4+ 6PE

By configuring BGP4+ IPv6 Provider Edge (6PE), you can connect separated IPv6 networks
through the MPLS tunneling technology.
Issue 02 (2014-09-30)
peer 2001:db8:8::1 bfd min-tx-interval 100 min-rx-interval 100 detect-
multiplier 4
peer 2001:db8:8::1 bfd enable
peer 2001:db8:9::1:2 as-number 200
#
ipv4-family unicast
undo synchronization
#
ipv6-family unicast
undo synchronization
network 2001:db8:7:: 64
peer 2001:db8:8::1 enable
peer 2001:db8:8::1 route-policy 10 export
peer 2001:db8:9::1:2 enable
#
route-policy 10 permit node 10
apply cost 100
#
return
Configuration file of Router C
#
sysname RouterC
#
ipv6
#
interface interface GigabitEthernet1/0/0
undo shutdown
ipv6 enable
ipv6 address 2001:db8:9::1:2/64
#
interface interface GigabitEthernet2/0/0
undo shutdown
ipv6 enable
ipv6 address 2001:db8:10::2/64
#
interface LoopBack0
ip address 3.3.3.3 255.255.255.255
#
bgp 200
router-id 3.3.3.3
peer 2001:db8:9::1:1 as-number 200
peer 2001:db8:10::1 as-number 100
#
ipv4-family unicast
undo synchronization
#
ipv6-family unicast
undo synchronization
peer 2001:db8:9::1:1 enable
peer 2001:db8:10::1 enable
peer 2001:db8:10::1 route-policy 10 export
#
route-policy 10 permit node 10
apply cost 150
#
return
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
9 BGP4+ Configuration
1137