Checking The Configurations - Huawei Quidway NetEngine80E Configuration Manual

HUAWEI NetEngine80E/40E Router
Configuration Guide - IP Routing
----End

9.16.5 Checking the Configurations

After BGP4+ network security is configured, you can check authentication information of BGP4
+ peers.
Prerequisites
BGP4+ security has been configured.
Procedure
l
l
l
----End
9.17 Maintaining BGP4+
Maintaining BGP4+ involves resetting a BGP4+ connection and clearing BGP4+ statistics.
9.17.1 Resetting BGP4+ Connections
Resetting a BGP4+ connection will interrupt the peer relationship. You can also reset BGP in
GR mode.
Issue 02 (2014-09-30)
NOTE
If only the default action is configured and the GTSM policy is not configured, GTSM does
not take effect.
Run the display gtsm statistics { slot-id | all } command to check the statistics of GTSM.
Run the display gtsm statistics command. You can view GTSM statistics on each board,
including the total number of BGP4+ packets, the total number of OSPF packets, the
number of packets that match the GTSM policy, and the number of discarded packets.
Run the display bgp ipv6 peer ipv6-address verbose command to check information about
BGP4+ GTSM.
Run the display bgp group [ group-name ] command to check GTSM of a BGP4+ peer
group.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
9 BGP4+ Configuration

1120