Set Radius Accounting - Enterasys SecureStack C2 Configuration Manual

set radius accounting

Mode
Switch command, read‐only.
Defaults
If no parameters are specified, all RADIUS accounting configuration information will be
displayed.
Example
This example shows how to display RADIUS accounting configuration information. In this case,
RADIUS accounting is not currently enabled and global default settings have not been changed.
One server has been configured.
For details on enabling and configuring RADIUS accounting, refer to "set radius accounting" on
page 18‐8:
C2(ro)->show radius accounting
RADIUS accounting status:
RADIUS Acct Server
------------------
1
set radius accounting
Use this command to configure RADIUS accounting.
Syntax
set radius accounting {[enable | disable] [retries retries] [timeout timeout]
[server ip_address port [server-secret]
Parameters
enable | disable
retries retries
timeout timeout
server ip_address
port server‐secret
Mode
Switch command, read‐write.
Defaults
None.
18-8 Security Configuration
Disabled
IP Address Acct-Port Retries Timeout Status
---------- --------- ------- ------- ------
172.16.2.10 1856
Enables or disables the RADIUS accounting client.
Sets the maximum number of attempts to contact a specified RADIUS
accounting server before timing out. Valid retry values are 0 ‐ 10.
Sets the maximum amount of time (in seconds) to establish contact with a
specified RADIUS accounting server before timing out. Valid timeout
values are 1 ‐ 30.
Specifies the accounting server's:
• IP address
• UDP authentication port (0 ‐ 65535)
• server‐secret (Read‐Write password to access this accounting server.
Device will prompt for this entry upon creating a server instance, as
shown in the example below.)
3 20 Disabled