Router Id - Enterasys SecureStack C2 Configuration Manual

Table 17-2 OSPF Configuration Task List and Commands (Continued)
To do this...
• Configure OSPF authentication.
Configure OSPF Areas.
• Configure an administrative distance.
• Define the range of addresses to be used
by Area Boundary Routers (ABRs).
• Define an area as a stub area.
• Set the cost value for the default route that
is sent into a stub area.
• Define an area as an NSSA.
Create virtual links.
Enable redistribution from non-OSPF
routes.
Monitor and maintain OSPF.

router id

Use this command to set the OSPF router ID for the device. This IP address must be set manually
in order to run OSPF. The no form of this command removes the router ID for the device.
Syntax
router id ip-address
no router id
Parameters
ip‐address
Defaults
None.
Mode
Router configuration: C2(su)‐>router(Config‐router)#
Specifies the IP address that OSPF will use as the router ID.
Use these commands...
"ip ospf authentication-key" on page 17-18
"ip ospf message digest key
"distance ospf" on page 17-19
"area range" on page 17-20
"area stub" on page 17-21
"area default cost" on page 17-22
"area nssa" on page 17-22
"area virtual-link" on page 17-23
"redistribute" on page 17-24
"show ip ospf" on page 17-25
"show ip ospf neighbor" on page 17-28
"show ip ospf interface" on page 17-27
"show ip ospf neighbor" on page 17-28
"show ip ospf virtual-links" on page 17-29
"clear ip ospf process" on page 17-30
SecureStack C2 Configuration Guide 17-11
router id
md5" on page 17-19