Clear Dhcp Pool Next-Server; Set Dhcp Pool Lease - Enterasys SecureStack C2 Configuration Manual

Mode
Switch command, read‐write.
Example
This example specifies the file server from which clients being served by address pool "auto1"
should download the boot image file "image1.img."
C2(rw)->set dhcp pool auto1 bootfile image1.img
C2(rw)->set dhcp pool auto1 next-server 10.1.1.10

clear dhcp pool next-server

Use this command to remove the boot image file server from the address pool being configured.
Syntax
clear dhcp pool poolname next-server
Parameters
poolname
Defaults
None.
Mode
Switch command, read‐write.
Example
This example removes the file server from address pool "auto1."
C2(rw)->clear dhcp pool auto1 next-server

set dhcp pool lease

Use this command to specify the duration of the lease for an IP address assigned by the DHCP
server from the address pool being configured.
Syntax
set dhcp pool poolname lease {days [hours [minutes]] | infinite}
Parameters
all
poolname
days
Specifies the name of the address pool. Pool names may be up to 31
characters in length.
(Optional) Clears user‐defined configuration parameters (and stack unit
numbers and priorities, if applicable).
Specifies the name of the address pool. Pool names may be up to 31
characters in length.
Specifies the number of days an address lease will remain valid. Value
can range from 0 to 59.
clear dhcp pool next-server
SecureStack C2 Configuration Guide 14-21