Set Rmon Channel; Clear Rmon Channel - Enterasys SecureStack C2 Configuration Manual

set rmon channel

set rmon channel
Use this command to configure an RMON channel entry.
Syntax
set rmon channel index port-string [accept {matched | failed}] [control {on | off}]
[description description] [owner owner]
Parameters
index
port‐string
accept matched |
failed
control on | off
description
description
owner owner
Defaults
If an action is not specified, packets will be accepted on filter matches.
If not specified, control will be set to off.
If a description is not specified, none will be applied.
If owner is not specified, it will be set to monitor.
Mode
Switch command, read‐write.
Example
This example shows how to create an RMON channel entry:
C2(rw)->set rmon channel 54313 ge.2.12 accept failed control on description
"capture all"

clear rmon channel

Use this command to clear an RMON channel entry.
Syntax
clear rmon channel index
13-16 RMON Configuration
Specifies an index number for this entry. An entry will automatically be
created if an unused index number is chosen. Maximum number of
entries is 2. Maximum value is 65535.
Specifies the port on which traffic will be monitored.
(Optional) Specifies the action of the filters on this channel as:
• matched ‐ Packets will be accepted on filter matches
• failed ‐ Packets will be accepted if they fail a match
(Optional) Enables or disables control of the flow of data through the
channel.
(Optional) Specifies a description for this channel.
(Optional) Specifies the name of the entity that configured this entry.