Show Eapol Output Details - Enterasys SecureStack C2 Configuration Manual

show eapol
Syntax
show eapol [port-string]
Parameters
port‐string
Defaults
If port‐string is not specified, only EAPOL enable status will be displayed.
Mode
Switch command, read‐only.
Example
This example shows how to display EAPOL status for ports
C2(su)->show eapol ge.1.1-3
EAPOL is disabled.
Port
--------
ge.1.1
ge.1.2
ge.1.3
Table 18‐2 provides an explanation of the command output. For details on using the set eapol
command to enable the protocol and assign an authentication mode, refer to "set eapol" on
page 18‐17.
Table 18-2 show eapol Output Details
Output
Port
18-16 Security Configuration
(Optional) Displays EAPOL status for specific port(s). For a detailed
description of possible port‐string values, refer to "Port String Syntax Used
in the CLI" on page 5‐2.
Authentication State
--------------------
Initialize
Initialize
Initialize
What It Displays...
Port designation. For a detailed description of possible port-string values, refer to
"Port String Syntax Used in the
.1.1‐3:
ge
Authentication Mode
--------------------
Auto
Auto
Auto
CLI" on page 5-2.