section. WebView can also be securely used over SSL port 443, if SSL is enabled on the switch. By
default, SSL is disabled.
To use WebView, type the IP address of the switch in your browser. To use WebView over SSL,
type in https:// then the IP address of the switch. For example, https://172.16.2.10.
Commands
For information about...
show webview
set webview
show ssl
set ssl
show webview
Use this command to display WebView status.
Syntax
show webview
Parameters
None.
Defaults
None.
Mode
Switch command, read‐only.
Example
This example shows how to display WebView status:
C2(rw)->show webview
WebView is Enabled.
set webview
Use this command to enable or disable WebView on the switch.
Syntax
set webview {enable | disable}
Parameters
enable | disable
Enable or disable WebView on the switch.
show webview
Refer to page...
3-49
3-49
3-50
3-50
SecureStack C2 Configuration Guide 3-49