Clear Port Priority - Enterasys SecureStack C2 Configuration Manual

5, the frames received through that port without a priority indicated in their tag header are
classified as a priority 5.
A frame with priority information in its tag header is transmitted according to that priority.
Syntax
set port priority port-string priority
Parameters
port‐string
priority
Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to set a default priority of 6 on
without priority information in their frame header are set to the default setting of 6:
C2(su)->set port priority ge.1.3 6

clear port priority

Use this command to reset the current CoS port priority setting to 0. This will cause all frames
received without a priority value in its header to be set to priority 0.
Syntax
clear port priority port-string
Parameters
port‐string
Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to reset
Specifies the port for which to set priority. For a detailed description of
possible port‐string values, refer to "Port String Syntax Used in the CLI" on
page 5‐2.
Specifies a value of 0 to 7 to set the CoS priority for the port entered in the
port‐string. Priority value of 0 is the lowest priority.
Specifies the port for which to clear priority. For a detailed description of
possible port‐string values, refer to "Port String Syntax Used in the CLI" on
page 5‐2.
.1.11 to the default priority:
ge
.1.3. Frames received by this port
ge
SecureStack C2 Configuration Guide 10-3
clear port priority