Set Dhcp Bootp - Enterasys SecureStack C2 Configuration Manual

set dhcp
For information about...
set dhcp exclude
clear dhcp exclude
set dhcp ping
clear dhcp ping
show dhcp binding
clear dhcp binding
show dhcp server statistics
clear dhcp server statistics
set dhcp
Use this command to enable or disable the DHCP server functionality on the SecureStack C2.
Syntax
set dhcp {enable | disable}
Parameters
enable | disable
Defaults
None.
Mode
Switch command, read‐write.
Example
This example enables DHCP server functionality.
C2(rw)->set dhcp enable

set dhcp bootp

Use this command to enable or disable automatic address allocation for BOOTP clients. By
default, address allocation for BOOTP clients is disabled. Refer to RFC 1534, "Interoperation
Between DHCP and BOOTP," for more information.
Syntax
set dhcp bootp {enable | disable}
14-4 DHCP Server Configuration
Enables or disables DHCP server functionality. By default, DHCP server
is disabled.
Refer to page...
14-7
14-7
14-8
14-8
14-9
14-9
14-10
14-10