address
Parameters
vlan vlan‐id
vrid
Defaults
None.
Mode
Router configuration: C2(su)->router(Config-router)#
Usage
This command must be executed to create an instance of VRRP on a routing interface (VLAN)
before any other VRRP settings can be configured.
Example
This example shows how to create a VRRP session on the VLAN 1 interface with a VRID of 1:
C2(su)->router(Config)#router vrrp
C2(su)->router(Config-router)#create vlan 1 1
address
Use this command to configure a virtual router IP address. The no form of this command clears
the VRRP address configuration.
Syntax
address vlan vlan-id vrid ip-address owner
no address vlan vlan-id vrid ip-address owner
Parameters
vlan vlan‐id
vrid
ip‐address
owner
Defaults
None.
17-40 IPv4 Routing Protocol Configuration
Specifies the number of the VLAN on which to create a VRRP session. This
VLAN must be configured for IP routing as described in "Pre‐Routing
Configuration Tasks" on page 15‐1.
Specifies a unique Virtual Router ID (VRID) to associate with the routing
interface.
Specifies the number of the VLAN on which to configure a virtual router
address. This VLAN must be configured for IP routing as described in "Pre‐
Routing Configuration Tasks" on page 15‐1.
Specifies a unique Virtual Router ID (VRID) associated with the routing
interface.
Specifies the virtual router IP address to associate with the router.
Specifies a value to indicate if the router owns the IP address as one of its
interfaces. Valid values are:
•
1 to indicate the router owns the address.
•
0 to indicate the router does not own the address.