Show Spantree Legacypathcost; Set Spantree Legacypathcost - Enterasys SecureStack C2 Configuration Manual

show spantree legacypathcost

Parameters
None.
Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to reset the SpanGuard trap function to enabled:
C2(rw)->clear spantree spanguardtrapenable
show spantree legacypathcost
Use this command to display the default Spanning Tree path cost setting.
Syntax
show spantree legacypathcost
Parameters
None.
Defaults
None.
Mode
Switch command, read‐only.
Example
This example shows how to display the default Spanning Tree path cost setting.
C2(su)->show spantree legacypathcost
Legacy Path Cost is disabled.

set spantree legacypathcost

Use this command to enable or disable legacy (802.1D) path cost values.
Syntax
set spantree legacypathcost {disable | enable}
7-30 Spanning Tree Configuration