Enable - Enterasys SecureStack C2 Configuration Manual

Syntax
preempt vlan-id vrid
no preempt vlan-id vrid
Parameters
vlan vlan‐id
vrid
Defaults
None.
Mode
Router configuration: C2(su)‐>router(Config‐router)#
Usage
Preempt is enabled on VRRP routers by default, which allows a higher priority backup router to
preempt a lower priority master.
The router that owns the virtual router IP address always preempts other routers, regardless of
this setting.
Example
This example shows how to disable preempt mode on the VLAN 1 interface, VRID 1:
C2(su)->router(Config)#router vrrp
C2(su)->router(Config-router)#no preempt vlan 1 1

enable

Use this command to enable VRRP on an interface. The no form of this command disables VRRP
on an interface.
Syntax
enable vlan vlan-id vrid
no enable vlan vlan-id vrid
Parameters
vlan vlan‐id
vrid
Defaults
None.
Specifies the number of the VLAN on which to set preempt mode. This
VLAN must be configured for IP routing as described in "Pre‐Routing
Configuration Tasks" on page 15‐1.
Specifies a unique Virtual Router ID (VRID) associated with the routing
interface. Valid values are from 1 to 255.
Specifies the number of the VLAN on which to enable VRRP. This VLAN
must be configured for IP routing as described in "Pre‐Routing
Configuration Tasks" on page 15‐1.
Specifies the Virtual Router ID (VRID) associated with the vlan‐id. Valid
values are from 1 to 255.
SecureStack C2 Configuration Guide 17-43
enable