Show Snmp View - Enterasys SecureStack C2 Configuration Manual

show snmp view

Use this command to display the MIB configuration for SNMPv3 view‐based access (VACM).
Syntax
show snmp view [viewname] [subtree oid-or-mibobject] [volatile | nonvolatile |
read-only]
Parameters
viewname
subtree oid‐or‐mibobject
volatile | nonvolatile |
read‐only
Defaults
If no parameters are specified, all SNMP MIB view configuration information will be displayed.
Mode
Switch command, read‐only.
Example
This example shows how to display SNMP MIB view configuration information:
C2(su)->show snmp view
--- SNMP MIB View information ---
View Name
Subtree OID
Subtree mask
View Type
Storage type
Row status
View Name
Subtree OID
Subtree mask
View Type
Storage type
Row status
View Name
Subtree OID
Subtree mask
View Type
Storage type
Row status
Table 6‐7 provides an explanation of the command output. For details on using the set snmp view
command to assign variables, refer to "set snmp view" on page 6‐20.
(Optional) Displays information for a specific MIB view.
(Optional) Displays information for a specific MIB subtree when
viewname is specified.
(Optional) Displays entries for a specific storage type.
= All
= 1
=
= included
= nonVolatile
= active
= All
= 0.0
=
= included
= nonVolatile
= active
= Network
= 1.3.6.1.2.1
=
= included
= nonVolatile
= active
show snmp view
SecureStack C2 Configuration Guide 6-19