Show Lldp Port Tx-Tlv; Show Lldp Port Location-Info - Enterasys SecureStack C2 Configuration Manual

Example
This example shows how to display LLDP port trap information for all ports.
C2(ro)->show lldp port trap
Trap-Enabled Ports
MED Trap-Enabled Ports:

show lldp port tx-tlv

Use this command to display information about which optional TLVs have been configured to be
transmitted on ports. Ports are configured to send optional TLVs with the set lldp port tx‐tlv
command.
Syntax
show lldp port tx‐tlv [port‐string]
Parameters
port‐string
Defaults
If port‐string is not specified, TLV configuration information will be displayed for all ports.
Mode
Switch command, read‐only.
Example
This example shows how to display transmit TLV information for three ports.
C2(ro)->show lldp port tx-tlv ge.1.1-3
* Means TLV is supported and enabled on this port
o Means TLV is supported on this port
Means TLV is not supported on this port
Column Pro Id uses letter notation for enable: s-stp, l-lacp, g-gvrp
Ports
-------
ge.1.1
ge.1.2
ge.1.3

show lldp port location-info

Use this command to display configured location information for one or more ports. Ports are
configured with a location value using the set lldp port location‐info command.
Syntax
show lldp port location-info [port-string]
:
(Optional) Displays information about TLV configuration for one or a
range of ports.
Port Sys Sys Sys Mgmt Vlan Pro
Desc Name Desc Cap Addr Id
---- ---- ---- --- ---- ---- ---- --- --- ---- ----
* * * * *
* * * * *
* * * * *
MAC PoE Link Max
Id PHY Aggr Frame Cap Pol Loc PoE
* slg * *
* slg * *
* slg * *
SecureStack C2 Configuration Guide 4-17
show lldp port tx-tlv
MED MED MED MED
--- --- --- ---
* * *
*
* * *