set rmon alarm status
Defaults
interval ‐ 3600 seconds
type ‐ absolute
startup ‐ rising
rthresh ‐ 0
fthresh ‐ 0
revent ‐ 0
fevent ‐ 0
owner ‐ monitor
Mode
Switch command, read‐write.
Example
This example shows how to configure a rising RMON alarm. This entry will conduct monitoring
of the delta between samples every 30 seconds:
C2(rw)->set rmon alarm properties 3 interval 30 object
1.3.6.1.4.1.5624.1.2.29.1.2.1.0 type delta rthresh 1 revent 2 owner Manager
set rmon alarm status
Use this command to enable an RMON alarm entry. An alarm is a notification that a statistical
sample of a monitored variable has crossed a configured threshold.
Syntax
set rmon alarm status index enable
Parameters
index
enable
Defaults
None.
Mode
Switch command, read‐write.
Usage
An RMON alarm entry can be created using this command, configured using the set rmon alarm
properties command ("set rmon alarm properties" on page 13‐9), then enabled using this
command. An RMON alarm entry can be created and configured at the same time by specifying
an unused index with the set rmon alarm properties command.
13-10 RMON Configuration
Specifies an index number for this entry. Maximum number or entries is
50. Maximum value is 65535.
Enables this alarm entry.