Enterasys SecureStack C2 Configuration Manual page 137
Stackable switches
Hide thumbs
Also See for SecureStack C2:
- Configuration manual (698 pages) ,
- Installation manual (34 pages)
Table of Contents
Advertisement
Syntax
clear lldp port tx-tlv {[all] | [port-desc] [sys-name] [sys-desc] [sys-cap] [mgmt-
addr] [vlan-id] [stp] [lacp] [gvrp] [mac-phy] [poe] [link-aggr] [max-frame] [med-
cap] [med-loc] [med-poe]} port-string
Parameters
all
port‐desc
sys‐name
sys‐desc
sys‐cap
mgmt‐addr
vlan‐id
stp
lacp
gvrp
mac‐phy
poe
link‐aggr
max‐frame
med‐cap
med‐loc
med‐poe
port‐string
Defaults
None.
Mode
Switch command, read‐write.
Disables all optional TLVs from being transmitted in LLDPDUs.
Disables the Port Description optional basic LLDP TLV from being
transmitted in LLDPDUs.
Disables the System Name optional basic LLDP TLV from being
transmitted in LLDPDUs.
Disables the System Description optional basic LLDP TLV from being
transmitted in LLDPDUs.
Disables the System Capabilities optional basic LLDP TLV from
being transmitted in LLDPDUs.
Disables the Management Address optional basic LLDP TLV from
being transmitted in LLDPDUs.
Disables the Port VLAN ID IEEE 802.1 Extensions TLV from being
transmitted in LLDPDUs.
Disables the Spanning Tree information defined by Protocol Identity
IEEE 802.1 Extensions TLV from being transmitted in LLDPDUs.
Disables the LACP information defined by Protocol Identity IEEE
802.1 Extensions TLV from being transmitted in LLDPDUs.
Disables the GVRP information defined by Protocol Identity IEEE
802.1 Extensions TLV from being transmitted in LLDPDUs.
Disables the MAC‐PHY Configuration/Status IEEE 802.3 Extensions
TLV from being transmitted in LLDPDUs.
Disables the Power via MDI IEEE 802.3 Extensions TLV from being
transmitted in LLDPDUs. Only valid for PoE‐enabled ports.
Disables the Link Aggregation IEEE 802.3 Extensions TLV from being
transmitted in LLDPDUs.
Disables the Maximum Frame Size IEEE 802.3 Extensions TLV from
being transmitted in LLDPDUs.
Disables the LLDP‐MED Capabilities TLV from being transmitted in
LLDPDUs.
Disables the LLDP‐MED Location Identification TLV from being
transmitted in LLDPDUs.
Disables the LLDP‐MED Extended Power via MDI TLV from being
transmitted in LLDPDUs. Only valid for PoE‐enabled ports.
Specifies the port or range of ports to be affected.
clear lldp port tx-tlv
SecureStack C2 Configuration Guide 4-31
Advertisement
Table of Contents
