Set Port Broadcast; Clear Port Broadcast - Enterasys SecureStack C2 Configuration Manual

ge.1.1
ge.1.2
ge.1.3
ge.1.4

set port broadcast

Use this command to set the broadcast suppression threshold, in packets per second, on one or
more ports. This sets a threshold on the broadcast traffic that is received and switched out to other
ports.
Syntax
set port broadcast port-string threshold-val
Parameters
port‐string
threshold‐val
Defaults
None.
Mode
Switch command, read‐write.
Example
This example configures ports 1 through 5 with a broadcast limit of 50 pps:
C2(su)->set port broadcast ge.1.1-5 50

clear port broadcast

Use this command to clear the broadcast threshold limit to the default value of 14881 for the
selected port.
Syntax
clear port broadcast port-string threshold
Parameters
port‐string
Defaults
None.
0 50
0 50
0 40
0 14881
Select the ports for which to configure broadcast suppression thresholds.
For a detailed description of possible port‐string values, refer to "Port
String Syntax Used in the CLI" on page 5‐2.
Sets the packets per second threshold on broadcast traffic. Maximum
value is 148810 for Fast Ethernet ports and 1488100 for Gigabit ports.
Select the ports for which to clear broadcast suppression thresholds. For a
detailed description of possible port‐string values, refer to "Port String
Syntax Used in the CLI" on page 5‐2.
set port broadcast
SecureStack C2 Configuration Guide 5-29