Managing Switch Configuration And Files; Configuration Persistence Mode; Purpose; Commands - Enterasys SecureStack C2 Configuration Manual

Managing Switch Configuration and Files

Managing Switch Configuration and Files

Configuration Persistence Mode

The default state of configuration persistence mode is "auto," which means that when CLI
configuration commands are entered, or when a configuration file stored on the switch is
executed, the configuration is saved to NVRAM automatically at the following intervals:
• On a stand‐alone unit, the configuration is checked every two minutes and saved if there has
been a change.
• On a stack, the configuration is saved across the stack every 30 minutes if there has been a
change.
If you want to save a running configuration to NVRAM more often than the automatic intervals,
execute the save config command and wait for the system prompt to return. After the prompt
returns, the configuration will be persistent.
You can change the persistence mode from "auto" to "manual" with the set snmp persistmode
command. If the persistence mode is set to "manual," configuration commands will not be
automatically written to NVRAM. Although the configuration commands will actively modify the
running configuration, they will not persist across a reset unless the save config command has
been executed.

Purpose

To set and view the persistence mode for CLI configuration commands, manually save the
running configuration, view, manage, and execute configuration files and image files, and set and
view TFTP parameters.

Commands

For information about...
show snmp persistmode
set snmp persistmode
save config
dir
show file
show config
configure
copy
delete
show tftp settings
set tftp timeout
clear tftp timeout
set tftp retry
clear tftp retry
3-36 Basic Configuration
Refer to page...
3-37
3-37
3-38
3-38
3-39
3-40
3-41
3-42
3-42
3-43
3-43
3-44
3-44
3-45