Clear Lldp - Enterasys SecureStack C2 Configuration Manual

clear lldp

med‐poe
port‐string
Defaults
None.
Mode
Switch command, read‐write.
Example
This example configures the management address, MED capability, and MED location
identification TLVs to be sent in LLDPDUs by port
C2(rw)->set lldp port tx-tlv mgmt-addr med-cap med-loc ge.1.1
clear lldp
Use this command to return LLDP parameters to their default values.
Syntax
clear lldp {all | tx-interval | hold-multiplier | trap-interval | med-fast-repeat}
Parameters
all
tx‐interval
hold‐multiplier
trap‐interval
med‐fast‐repeat
Defaults
None.
Mode
Switch command, read‐write.
Example
This example returns the transmit interval to the default value of 30 seconds.
C2(rw)->clear lldp tx-interval
4-28 Discovery Protocol Configuration
LLDP‐MED Extended Power via MDI TLV. Values sent include the
Power Limit (total power the port is capable of sourcing over a
maximum length cable) and the power priority configured on the
port. Only valid for PoE‐enabled ports.
Specifies the port or range of ports to be affected.
ge
Returns all LLDP configuration parameters to their default values,
including port LLDP configuration parameters.
Returns the number of seconds between transmissions of LLDP
frames.to the default of 30 seconds.
Returns the multiplier to apply to the transmit interval to determine
the time‐to‐live value to the default value of 4.
Returns the minimum time between LLSP trap transmissions to the
default value of 5 seconds.
Returns the number of fast start LLDPDUs to be sent when an LLDP‐
MED endpoint device is detected to the default of 3.
.1.1.