Set Newaddrtrap - Enterasys SecureStack C2 Configuration Manual

Parameters
port‐string
Defaults
If port‐string is not specified, the status of the new MAC addresses trap function will be displayed
for all ports.
Mode
Switch command, read‐only.
Usage
By default, this function is disabled globally and per port.
Example
This example displays the status for Gigabit Ethernet ports 1 through 5 in slot 1.
C2(ro)->show newaddrtrap ge.1.1-5
New Address Traps Globally disabled
Port
--------- ------------
ge.1.1
ge.1.2
ge.1.3
ge.1.4
ge.1.5

set newaddrtrap

Use this command to enable or disable SNMP trap messaging, globally or on one or more ports,
when new source MAC addresses are detected.
Syntax
set newaddrtrap [port-string] {enable | disable}
Parameters
port‐string
enable | disable
Defaults
If port‐string is not specified, the trap function is set globally.
Mode
Switch mode, read‐write.
(Optional) Displays the status of the new MAC addresses trap function
on specific ports.
Enable State
disabled
disabled
disabled
disabled
disabled
(Optional) Enable or disable the new MAC addresses trap function on
specific ports.
Enable or disable the new MAC addresses trap function. If entered
without the port‐string parameter, enables or disables the function
globally. When entered with the port‐string parameter, enables or
disables the function on specific ports.
set newaddrtrap
SecureStack C2 Configuration Guide 6-29