Clear Dhcp Pool Netbios-Node-Type; Set Dhcp Pool Option - Enterasys SecureStack C2 Configuration Manual

Syntax
set dhcp pool poolname netbios-node-type {b-node | h-node | p-node | m-node}
Parameters
poolname
b‐node
h‐node
p‐node
m‐node
Defaults
None.
Mode
Switch command, read‐write.
Example
This example specifies hybrid as the NetBIOS node type for the address pool "auto1."
C2(rw)->set dhcp pool auto1 netbios-node-type h-node

clear dhcp pool netbios-node-type

Use this command to remove the NetBIOS node type from the address pool being configured.
Syntax
clear dhcp pool poolname netbios-node-type
Parameters
poolname
Defaults
None.
Mode
Switch command, read‐write.
Example
This example removes the NetBIOS node type from the address pool "auto1."
C2(rw)->clear dhcp pool auto1 netbios-node-type

set dhcp pool option

Use this command to configure DHCP options, described in RFC 2132.
Specifies the name of the address pool. Pool names may be up to 31
characters in length.
Specifies the NetBIOs node type to be broadcast (no WINS).
Specifies the NetBIOs node type to be hybrid (WINS, then broadcast).
Specifies the NetBIOs node type to be peer (WINS only).
Specifies the NetBIOs node type to be mixed (broadcast, then WINS).
Specifies the name of the address pool. Pool names may be up to 31
characters in length.
clear dhcp pool netbios-node-type
SecureStack C2 Configuration Guide 14-27