Show Snmp Notify - Enterasys SecureStack C2 Configuration Manual

show snmp notify

Usage
This command enables and disables sending SNMP trap messages when a new source MAC
address is detected by a port. If the port is a CDP port, however, traps for new source MAC
addresses will not be sent.
The default mode is disabled globally and per port.
Example=
This example enables the trap function globally and then on Gigabit Ethernet ports 1 through 5 in
slot 1.
C2(rw)->set newaddrtrap enable
C2(rw)->set newaddrtrap ge.1.1-5 enable
show snmp notify
Use this command to display the SNMP notify configuration, which determines the management
targets that will receive SNMP notifications.
Syntax
show snmp notify [notify] [volatile | nonvolatile | read-only]
Parameters
notify
volatile |
nonvolatile | read‐
only
Defaults
If a notify name is not specified, all entries will be displayed.
If volatile, nonvolatile, or read‐only are not specified, all storage type entries will be displayed.
Mode
Switch command, read‐only.
Example
This example shows how to display the SNMP notify information:
C2(su)->show snmp notify
--- SNMP notifyTable information ---
Notify name
Notify Tag
Notify Type
Storage type
Row status
Notify name
Notify Tag
Notify Type
Storage type
Row status
6-30 SNMP Configuration
(Optional) Displays notify entries for a specific notify name.
(Optional) Displays notify entries for a specific storage type.
= 1
= Console
= trap
= nonVolatile
= active
= 2
= TrapSink
= trap
= nonVolatile
= active