Clear Arp-Cache; Configuring Broadcast Settings; Purpose; Commands - Enterasys SecureStack C2 Configuration Manual

clear arp-cache

Use this command to delete all nonstatic (dynamic) entries from the ARP table.
clear arp-cache
Parameters
None.
Mode
Privileged EXEC: C2(su)‐>router#
Defaults
None.
Example
This example shows how to delete all dynamic entries from the ARP table:
C2(su)->router#clear arp-cache

Configuring Broadcast Settings

Purpose

To configure IP broadcast settings. By default, interfaces on the SecureStack C2 do not forward
broadcast packets.

Commands

For information about...

ip directed-broadcast

ip helper-address
ip directed-broadcast
Use this command to enable or disable IP directed broadcasts on an interface. By default,
interfaces on the SecureStack C2 do not forward directed broadcasts. The no form of this
command disables IP directed broadcast on the interface.
Syntax
ip directed-broadcast
no ip directed-broadcast
Parameters
None.
Refer to page...
16-11
16-12
SecureStack C2 Configuration Guide 16-11
clear arp-cache