Ip Access-Group - Enterasys SecureStack C2 Configuration Manual

move destination
source1 source2
Defaults
If insert, replace, or move are not specified, the new entry will be appended to the access list.
If source2 is not specified with move, only one entry will be moved.
If operator and port are not specified, access parameters will be applied to all TCP or UDP ports.
Mode
Global configuration: C2(su)‐>router(Config)#
Usage
Access lists are applied to interfaces by using the ip access‐group command as described in "ip
access‐group" on page 18‐74.
Valid access‐list‐numbers for extended ACLs are 100 to 199. For standard ACLs, valid values are 1
to 99.
Example
This example shows how to define access list 101 to deny ICMP transmissions from any source
and for any destination:
C2(su)->router(Config)#access-list 101 deny ICMP any any

ip access-group

Use this command to apply access restrictions to inbound frames on an interface when operating
in router mode. The no form of this command removes the specified access list.
Syntax
ip access-group access-list-number in
no ip access-group access-list-number in
Parameters
access‐list‐number
in
Defaults
None.
Mode
Interface configuration: C2(su)‐>router(Config‐if(Vlan <vlan_id>))#
(Optional) Moves a sequence of access list entries before another entry.
Destination is the number of the existing entry before which this new entry
will be moved. Source1 is a single entry number or the first entry number in
the range to be moved. Source2 (optional) is the last entry number in the
range to be moved. If source2 is not specified, only the source1 entry will be
moved.
Specifies the number of the access list to be applied to the access list. This
is a decimal number from 1 to 199.
Filters inbound frames.
ip access-group
SecureStack C2 Configuration Guide 18-79